Ammonia and Nitrite both tested about 1ppm at 1pm
Added Fritz bacteria
Nitrite tested at .25.
Added more ammonia at 1PM.
BRS shipped replacement pump for skimmer.
Ammonia tested at 0 for first time.
Nitrite still over 1.
Worked on plumbing for reactors. Mostly finished but need to get some more hose clamps before powering up pump.
Continued to tweak power head placement. I think I have them in a good spot now.
Started up skimmer but am having issues with pump.
Added ammonia for cycling at 12 noon.
Started setup of apex unit. Setup all modules and EB units.
PH probe would not calibrate, opened a ticket with apex, waiting on new calibration fluid to try and calibrate again.
Temp probe successfully installed, compared against thermometer and appeared accurate.
ORP probe installed.
Conductivity probe successfully calibrated and installed.
Heaters installed and tank brought up to temp.
WAV powerheads installed. Still need to fine tune placement and output as it is created bare spots or canyons in sand at front of tank.
ATI Powermodule light installed and programmed.
Rock, sand, and water started going into the tank Thursday night at about 6:30pm, finished time approximately 830pm.